Earlier this week I found out that it was possible to passthrough the Integrated GPU (iGPU) for standard Intel NUC which was motivated by a question I had saw on the VMware Subreddit. I have written about iGPU passthrough for Intel NUCs before but only for the higher end models which were the Hades Canyon NUC at the time.
Neat! Just found out you can actually passthrough the iGPU of standard Intel NUC. The trick looks to be enabling passthrough using ESXi Embedded Host Client UI & then you can assign it using vSphere UI#Homelab pic.twitter.com/NwuxbXwUMj
— William Lam (@lamw.bsky.social | @*protected email*) (@lamw) June 15, 2020
To be honest, I never thought about trying this out with a standard NUC as I figured the iGPU may not be powerful enough or warrant any interests. After sharing the news on Twitter, I came to learn from the community that not only is this desirable for various use cases but some folks have also been doing this for some time now and have shared some the benefits it brings for certain types of workloads.
Can’t take credit. It was one of our collegaues that pointet me to it. Hw transcoding went up a factor of almost x 20. So for specefic workloads the nuc is suddently a lot more capable than before.
— Robert Jensen (@rhjensen) June 15, 2020
I’ve been doing this forever, when I need to crack passwords but don’t need the full 7 gpu rig - all Supermicro and 1080ti GPUs these dayshttps://t.co/GJGRV5eu8f
— Rob VandenBrink (@rvandenbrink) June 15, 2020
seems like this would be great for ESXi + Plex hardware transcoding
— Will Beers (@willbeers) June 15, 2020
Below are the instructions I used to enable iGPU passthrough on an Intel NUC 10 (Frost Canyon) with vSphere 7.0. These instructions should also be applicable for other NUC models and earlier versions of vSphere including details around passthrough configuration persistency which I know some folks have ran into which I was able to figure out as part of this experiment.
